Trad Gang

Main Boards => The Shooters FORM Board => Topic started by: Paul Mattson on April 27, 2010, 08:13:00 AM

Title: Cork Screwing Arrows ???
Post by: Paul Mattson on April 27, 2010, 08:13:00 AM

My arrows are cork screwing at least 7 out of 10 or more shots.  My arrows are Arrow Dynamic Trad Lites 30".
   My bow is a DAS Dalaa with Carbon Max Limbs (Med) 50#.  Shooting from a rest with plunger.  Draw length is 29"

    I have only been shooting this bow for a few weeks and just can't seem get the arrows flying good.  I can get them to group good but, the cork screwing will not stop.  Anyone have any suggestions?

Title: Re: Cork Screwing Arrows ???
Post by: tradtusker on April 27, 2010, 12:39:00 PM

sounds like the spine and nocking point is off.

Have you bare shaft tuned?

Title: Re: Cork Screwing Arrows ???
Post by: CEO on April 28, 2010, 01:21:00 AM

Had the same thing happen with AD Trads when nocking point was too low.

Title: Re: Cork Screwing Arrows ???
Post by: eric-thor on May 03, 2010, 03:30:00 PM

http://bowmaker.net/tuning.htm