Trad Gang

Main Boards => The Shooters FORM Board => Topic started by: franklinmanklin on July 16, 2011, 09:08:00 PM

Title: Titan Border Tuning???
Post by: franklinmanklin on July 16, 2011, 09:08:00 PM

I have a Titan riser, Border medium limbs, 50# or so at 28", I draw about 30".  Shooting 3 under, Axis 400s, 250 grain heads.  I made an adjustable riser plate to adjust the center shot in and out.  I have decent flight but not perfect flight.  Should I try 500 spines or is there something else that is amuck?

Title: Re: Titan Border Tuning???
Post by: on July 16, 2011, 10:50:00 PM

400's with 250 grains up front sounds about right.  Curious... do you have the tip of your arrow slightly past the string?  

Don't know what you've done, but to start I would probably set the tiller from 0 to 1/16" positive, brace at about 8.25", and the nock set about 3/8" high and bare shaft to see where I am.

Title: Re: Titan Border Tuning???
Post by: franklinmanklin on July 17, 2011, 09:10:00 PM

I have tried the arrow like you described but the best is way in, that is why I think the arrows are too stiff.

I will try the brace height like you said.