Trad Gang

Main Boards => PowWow => Topic started by: finger lakes bowhunter on January 05, 2008, 09:48:00 AM

Title: limbs for the GameMaster II
Post by: finger lakes bowhunter on January 05, 2008, 09:48:00 AM

Hey All,

I am still new to the sport.  I am packing up my compound to be sold today!! While reading this forum I see that most of you look down on the hoyt limbs. I have a short draw, not sure I think about 28".  I would like to get the dalla limbs for the 58" but I am not sure if it would be a good fit with the long riser.  Any thoughts?

Title: Re: limbs for the GameMaster II
Post by: Bob Morrison on January 05, 2008, 04:42:00 PM

Jonathan, Will the riser take the ILF limbs and what is the length of the riser?

Bob

Title: Re: limbs for the GameMaster II
Post by: KodiakBob on January 05, 2008, 05:23:00 PM

The GMII needs to have adaptors put in ILF limbs before they will fit. If you are gettting a GMII I would shoot it before buying any ILF limbs, The limbs that come on the GMII are pretty good.

Title: Re: limbs for the GameMaster II
Post by: finger lakes bowhunter on January 08, 2008, 02:04:00 PM

Good to know. David at DAS said that there are adapters but I am still new to the sport so any advice helps me allot. I am not sure what the length of the riser is but it is long.

Title: Re: limbs for the GameMaster II
Post by: BCD on January 08, 2008, 03:49:00 PM

The GM riser is 21 inches-great bow. Mine stacks just a little at my 29 inch draw, but not bad. The DAS limbs are ridiculously expensive. There are others out there though-tradtech, sabastian flute, KAP winstorm.

Good Luck