Trad Gang
Main Boards => Hunting Knives and Crafters => Topic started by: Izzy on March 28, 2008, 11:20:00 AM
-
Hello.To you folks who have worked with mammoth, do scales grind well on a belt sander?Are there any special considerations to working on it? I guess I only want to sand the scales to mathch the profile of the tang and also file the pins down after theyre inserted.I was thinking of having it done but I figure it would be more fun to do it myself.I will be mounting the scales on a damascuss blade.I almost forgot,,, what type of drill bit would you use to drill the pin holes?
Thanks,Izzy
-
I assume your talking Mammoth tooth Iz? You can grind it on the belt sander but only to rough it out. I'm afraid trying to fine grind you'll wind up burning it. I do everything below 50gr by hand, stepping to 120gr, 320gr, 600gr... Make very certain you go easy and are working only it's been stabilized or it's apt to crumble on you. Some is better than other but it's better safe than sorry.
Same with drilling holes, go thru very slow at fairly high RPMs.... I use regular HSS (high speed steel) bits. Be careful pushing the pins thru as you can break out the far side easily too.
I always take it one step at a time and stabilize with CA glue often, you can't be too careful with this stuff....
-
You ever try filling in with epoxy insteat of ca glue, or do you want it real thin to run into cracks?
-
I agree with Doug on all counts, especially if your using ivory. Anything to keep it cool and from adding too much direct pressure, as from the drill press. Use sharp bits and new belts. Dont know much about the mammoth teeth. Heard they were brittle and have managed to avoid them.
Lin
-
Yep Iz, like Lin said keeping ivory cool is even more important than it is on the mammoth tooth. Good ivory is considerable more durable than the tooth, just be sure to use sharp tools and new sandpaper. An occasional wipe down with mineral oil might help with the drying out.
The thinner the better Dan, lots of fine cracks and crevices in the mammoth tooth.
-
Dumb question. I love the way mammoth tooth looks but after reading about how fragile it is to work, is it prone to chipping or breaking if the knife is dropped? Mike
-
Bodork,
I have not used it, but have been around a lot of guys who have. It seems from what I hear that it very well could break when dropped. I also know that some guys wont use it because of that.
It certainly has a unique look that is attractive on some knives. If I were to use it, I would put it on a frame style handle so the handle's strength would come from the frame and fully support the tooth.
All this said, I imagine there are lots of using knives with Mammoth tooth that are holding up well for the intended use.
Lin
-
Well, Ive been sanding the scales to shape with sand paper and Dremmel tool.Im trying to keep it at room temp and not let it overheat.Its taking some time but all worthy projects do.Ill be sure to post when done.