Trad Gang
Main Boards => Hunting Knives and Crafters => Topic started by: tippit on May 24, 2016, 11:47:00 AM
-
Tried to draw and forge taper an old hidden tag blade that I never finished. I didn't have enough steel to draw out to make a Blacksmith Blade but it was good practice to draw, square, round and twist. Blade is 6 1/2" OAL and my four fingers fit inside the curve. It has been a busy week at the Tippit Forge. Once again many thanks to Lin...tippit
(http:// [url=http://imgur.com/yBb9UZ5] [img]http://i.imgur.com/yBb9UZ5.jpg?2)[/url] [/IMG]
(http:// [url=http://imgur.com/j7zXYJR] [img]http://i.imgur.com/j7zXYJR.jpg?1)[/url] [/IMG]
Plus I didn't like the Scotch Brite finish on Blacksmith Blade Version 2 so I threw it back into the forge for a redo...
(http:// [url=http://imgur.com/2fFKr3s] [img]http://i.imgur.com/2fFKr3s.jpg?2)[/url] [/IMG]
-
Good practice indeed. :campfire: