Trad Gang

Main Boards => Hunting Knives and Crafters => Topic started by: Lin Rhea on August 23, 2018, 04:06:16 PM

Title: Scagel look
Post by: Lin Rhea on August 23, 2018, 04:06:16 PM

(https://farm2.staticflickr.com/1875/43318379225_6aecc2d358_c.jpg) (https://flic.kr/p/28ZU1Xk)
(https://farm2.staticflickr.com/1898/44224057091_3623643fbd_c.jpg) (https://flic.kr/p/2anVRqX)

Title: Re: Scagel look
Post by: Jon Stewart on August 23, 2018, 09:56:30 PM

Very nice. Scagel lived just 8 miles from me. You would think there would be all kinds of Scagel knives around but I have yet to find one.

Title: Re: Scagel look
Post by: KSCATTRAPR on August 24, 2018, 09:24:36 PM

That is awesome, I love the stag!

Title: Re: Scagel look
Post by: jpsowers on August 24, 2018, 09:59:51 PM

It’s a beaut

Title: Re: Scagel look
Post by: Jon Stewart on August 25, 2018, 08:08:24 AM

There is one listed for  $10,000.00 on the Muskegon, Michigan craigslist page if anyone wants to see what a Scagel looks like to compare with the OP's knife. Pretty darn close.

Title: Re: Scagel look
Post by: Lin Rhea on August 27, 2018, 10:32:34 AM

Thanks guys. :campfire:

Title: Re: Scagel look
Post by: ron w on September 05, 2018, 09:59:16 PM

 :thumbsup: :thumbsup: :thumbsup: very cool

Title: Re: Scagel look
Post by: tippit on September 06, 2018, 08:49:03 PM

Beautiful knife Lin!  Question...the second picture looks like you edge quenched it?  If so, is that what you usually do?

Title: Re: Scagel look
Post by: Lin Rhea on September 07, 2018, 08:14:07 AM

Jeff, While I think of this as an edge quench, technically, I only heated the edge to critical and fully submerged the blade. I do this on smaller blades often but not always. When I can use that visible line to enhance or compliment the shape of the blade, I will. I have practiced this technique a lot and have rejected a few that didn't look right, or used another technique altogether as long as it didn't detract from it.

When I say I have practiced, I mean not only in the look but also in the heat control. I use a torch with a brazing tip. I'm careful not to heat the area to harden up into the grain growth temps and thus undo the benefits of my, already done, thermo cycling.

Title: Re: Scagel look
Post by: tippit on September 07, 2018, 03:11:09 PM

I've seen Joe Keeslar use a torch for quenching and a video of Ed Caffrey doing it.  I've edge quenched in the past with the entire blade at critical but didn't think my results were consistent.  How high on the blade do you heat the edge to critical before a total quench?

Title: Re: Scagel look
Post by: Lin Rhea on September 08, 2018, 07:42:10 AM

Jeff, I heat up about 1/2 inch of the edge. I start where there’s more mass and sort of paint the heat into it. Swapping sides during the heating.