Trad Gang

Main Boards => PowWow => Topic started by: SS Snuffer on September 05, 2024, 08:05:55 AM

Title: Bow quiver foam ?
Post by: SS Snuffer on September 05, 2024, 08:05:55 AM

I'm changing the foam in my Great Northern quiver. What holds it in place, glue? Dum question but I'm sure someone here has done it. I'm changing from 3 blade to 2 and would like to save the old in case I want to go back to 3 blade.

Thanks guys

Title: Re: Bow quiver foam ?
Post by: TSP on September 06, 2024, 03:08:15 PM

Mine was spot-glued, it came out fairly easily.  No need to replace the entire foam, simply cut off the top inch or so laterally, glue on a replacement 'slab' of foam to match what you cut off, then trim the replacement piece to shape.  Can use hot glue (in spots, not everywhere) to hold the finished product in the hood when done.

Title: Re: Bow quiver foam ?
Post by: SS Snuffer on September 06, 2024, 09:21:51 PM

Thanks Tony  much appreciated!

Title: Re: Bow quiver foam ?
Post by: Pat B on September 07, 2024, 11:46:43 AM

A small piece of double sided tape will work too.  :thumbsup:

Title: Re: Bow quiver foam ?
Post by: Kirkll on September 08, 2024, 09:52:36 AM

This glue works very nice for rest and strike plate materials on risers, and should work well for your foam insert as well…just go easy on it.


https://www.acehardware.com/departments/paint-and-supplies/tape-glues-and-adhesives/glues-and-epoxy/17338?store=15157&gad_source=1&gbraid=0AAAAADtqLJHotM7NIYqs3_7MCUfIx0ZEF&gclid=Cj0KCQjwlvW2BhDyARIsADnIe-JE1tc7Wv58CAmVWdT2A3CbQQYoyV94SgVNc1gNWoIqMJZvwl7O24kaAi14EALw_wcB&gclsrc=aw.ds