Trad Gang

Main Boards => PowWow => Topic started by: J. Holden on July 21, 2008, 11:50:00 AM

Title: Converting a slide on quiver
Post by: J. Holden on July 21, 2008, 11:50:00 AM

I may be posting this in the wrong spot.  If so I apologize in advance.  I was wondering if there is a way to convert my Selway Slide on Quiver from my recurve to a quick detach style for my lngbow.  Not sure if it's possible but my wheels are turning and was wondering if anybody else has done something similiar.  Thanks.

Jeremy

Title: Re: Converting a slide on quiver
Post by: dead-eye on July 21, 2008, 03:58:00 PM

Jeremy,

I was able to call up Selway and buy just the quick detach part of the quiver.  I then took my quiver apart, and put the new quick detach parts onto the hood and gripper.  This was much cheaper than buying a whole new quiver.  I'm not sure if they will still do this though..

Brendan

Title: Re: Converting a slide on quiver
Post by: J. Holden on July 22, 2008, 11:21:00 AM

Thanks Brendan.  I'll give them a call.

Jeremy

Title: Re: Converting a slide on quiver
Post by: Orion on July 22, 2008, 11:38:00 AM

Just slit the quiver openings so they'll slide over the limb from the side.  Then get appropriate size rubber O rings to slip over the slit end of the quiver arm.  May take two rings per arm.  May need to cut small grooves in the arms so the O rings don't slip off. I suppose electrical tape or duct tape would also work.  Little more time consuming to get off though.