Trad Gang
Main Boards => PowWow => Topic started by: dinorocks on September 18, 2008, 03:47:00 PM
-
I recently learned how to make cordage from dogbane and want to make a string for my self bow.
I've read the string chapter in the Bowyers Bible and I see that there are lots of different methods to make a string but I still have a few basic questions.
My "processed" dogbane fibers are ~1-3 feet long and from ~1/3 inch diameter plants.
I would like to make a string for my 48# Osage self bow.
Q1. Are there any helpful "how-to" sites for using dogbane to make bow strings?
Q2. Is it imperative to remove ALL flecks of remaining bark after hand-retting?
Q3. Any suggestions on how thick (strong) I should make my string, i.e. twist 2 halves of one plant to make one strand, etc? If so, will two strands folded over and twisted again give me the strength I need for a 48# bow? I read that I need to make the string 4X my bow weight.
Q3. Is there a preference to the way two sections of fibers are connected while twisting a strand, i.e. using the "V" or "L" technique or just adding to the short end with a new section of fiber?
Q4. How should I start/finish the ends of my string so I can attach it to my bow, i.e. use loops or tie to the end of the bow?
Thanks for any help or pictures!
Dino
-
Dino, not to take away from this great site but you might be better served by trying primitive archer or paleo planet for your answers.
Mods, I hope this is OK. If not, do what you have to do. Pat
-
Thanx for your post, Dino - interesting subject!
Pat B - Trad Gang has some folks with a serious depth of primitive archery, and Dino just might get what he's looking for right here in his own back yard. If not, and as you've alluded to, there are lots of other sources to inquire and research.
-
Rob, I probably phrased my post incorrectly. I apologize. I didn't mean any disrespect to anyone on TradGang that might have the information that Dino was asking about. Pat