Trad Gang

Main Boards => PowWow => Topic started by: maxwell on March 29, 2009, 08:13:00 PM

Title: Hoyt TD 3 riser
Post by: maxwell on March 29, 2009, 08:13:00 PM

I have an old Td 3 riser and limbs from the 70"s, the riser is magnesium and the limbs are to light I was wondering if these new I think ILF limbs would work on this riser or does it need to be worked on?  If it needs warfing or something who could do it>

Title: Re: Hoyt TD 3 riser
Post by: Aggie1993 on March 29, 2009, 08:25:00 PM

Do you have a pic of the riser?  I have owned two different hoyt "TD-3" risers-one was warfed and the other didn't need it and accepted the ILF limbs with a change of the ILF fitting to the DAS fitting.  Both are great risers.

Title: Re: Hoyt TD 3 riser
Post by: Mike Byrge on March 30, 2009, 08:47:00 AM

If your riser has the "thumb screws" on the belly and threaded insert in the limb, then you can swap out the ILF fitting with a DAS fitting on the limb and they should bolt right on to the riser.

Title: Re: Hoyt TD 3 riser
Post by: SpikeMaster on March 30, 2009, 08:55:00 AM

Pete Ward did a TD3 conversion on his web site.  www.peteward.com. (http://www.peteward.com.)  Scroll down on the left pane until you see Warf/TD3 Ilf. It seems like an easy conversion that most anyone can do.

Title: Re: Hoyt TD 3 riser
Post by: maxwell on March 30, 2009, 08:28:00 PM

up