Trad Gang

Main Boards => PowWow => Topic started by: 30pointbuck on March 10, 2011, 07:05:00 PM

Title: Installing Antler Limb Bolts
Post by: 30pointbuck on March 10, 2011, 07:05:00 PM

When installing the antler limb bolts do you remove the brass limb holder that the limb bolt goes through so the antler sets flush on the limb or do they stay on and the antler limb bolt goes through,

Title: Re: Installing Antler Limb Bolts
Post by: Migra Bill on March 10, 2011, 07:56:00 PM

I learned this one the hard way. Remove the brass bevel. That bevel and the screw that goies thru it is in case you dont have the antler bolts.

Title: Re: Installing Antler Limb Bolts
Post by: Bjorn on March 10, 2011, 08:12:00 PM

I remove the brass bevel and depending on how flush the limb bolt
sits on the limb and how I am feeling that day the flat nylon washer will get used or not.

Title: Re: Installing Antler Limb Bolts
Post by: Eugene Slagle on March 10, 2011, 08:14:00 PM

I always use the Flat Nylon washer because I don't like to scratch the limb in that area since it is where the limb is retained.