Trad Gang
Main Boards => PowWow => Topic started by: Machino on August 04, 2012, 12:13:00 AM
-
Can you heat broadheads up too much? I might have to switch arrows for better spine. Also, Is there a way to get all the glue off? Shooting Aces. A little is coming out of them, though it doesn't seam like a huge deal. Thanks.
-
If a broadhead gets to hot for you to handle you could ruin the temper on them. The best way to get glue out of the head is with something like a pipe cleaner.
-
If you are going to be using hot melt to attach to the new arrows, I wouldn't bother getting all of the glue out.
-
You will need the glue next time so don't worry about it too much and yes you can overheat a BH and put the temper at risk.
-
Originally posted by Bjorn:
You will need the glue next time so don't worry about it too much and yes you can overheat a BH and put the temper at risk.
Agreed. It's not only possible to over heat a broadhead, it's very easy to do. If the bevel turns blue, the temper/hardness is gone. If you're putting adapters in the BHDs, heat the adapter and put the glue on that. Then put the adapter in the head while the glue is still liquid. If it doesnt spin true, then heat the adapter to reset it, not the BHD. On wood shafts you really have no choice but to heat the BHD but use a very low flame directed into the ferrule and go slowly. Try to keep from heating up the blades any more than necessary.
Ron
-
Too hot to handle is only about 120-140F,, You won't take the temper out until around 400F when bear metal will start to turn color..
Regardless the glue will melt well under the 400 Mark.
Always put the heat on the ferrule and not the blade.
-
It is best not to use a tourch. I t is very hard to control the heat using a torch . I reccomend and use a alchol burner or a candle much easer to control and more even heat.
-
Originally posted by Earl E. Nov...mber:
Too hot to handle is only about 120-140F,, You won't take the temper out until around 400F when bear metal will start to turn color..
Regardless the glue will melt well under the 400 Mark.
Always put the heat on the ferrule and not the blade.
X2
-
Heat it just enough to melt the glue, that's all it takes.
-
I do it over a gas stove. I hold the head with pliers, and only let the flame of one "jet" inside the ferrule. The blade never heats up with this method. Obviously, put your melted glue on your shaft first.
-
Originally posted by Roger Norris:
I do it over a gas stove. I hold the head with pliers, and only let the flame of one "jet" inside the ferrule. The blade never heats up with this method. Obviously, put your melted glue on your shaft first.
Exactly how I do it...
-
Must be a Michigan thing :bigsmyl: