Trad Gang
Main Boards => PowWow => Topic started by: Johnny Reb on November 08, 2012, 09:18:00 PM
-
Anyone ever straighten a limb on a recurve ?? if so could you give a play by play on how you done it ??
Noticed a tiny bit of a twist on mine this evening, just enuff that the string was edging to one side of the string groove on the limb but you cant hardly tell by looking at the limb.
I tinkered with it for a while by drawing it & easing the string back down & it always went back into the same place in the groove.
-
Just gently hand twist it straight. Over twist a little until it stays straight.
If you are hand stringing your bow, get a bow stringer.
-
Charlie has it correct. I have straightened a couple of bows that way.
-
Gotcha, I've thought about try'n to just rub it untill it warmed up & bend it back in place, also considered steamimg but thought it mite be over kill.
I have a stringer but a ceratin 3 year old grandson has discovered it & now I'll have to rediscover it ... somewher.
Think'n its the results of leave'n it strung, from now on it'll be put up unstrung.
Thanks guys.
-
I agree completely with Charlie's method-definitely no hot water, no steam and no hair dryer. The glue often gives up at just under 140 degrees.
The twist is not from leaving it strung.........I have recurves that have been strung for years. Older recurves sometimes have slightly twisted limbs and generally it is the lower limb-why? It is because they spend years in a closet corner and the simple weight of the bow will cause the end of the lower limb to get twisted. IMO
-
I have had luck with rubbing the limb with a cloth (over wax) to warm it up and then over-twisting it opposite to the undesireable twist.
-
Yeah I was think'n the heat mite be over kill thats why I posted up before try'n anything, even tho its old & in less than perfect shape it still has plenty of life in it, great little bow it is.
StumpKiller :you mention wax, what type & whats the bennifit ?? ( retorical question somewhat)