Trad Gang
Main Boards => PowWow => Topic started by: Jock Whisky on August 04, 2014, 12:29:00 AM
-
I noticed my bow was making a bit too much noise lately. It was a buzzing or vibrating sound. I eliminated potential sources of noise one at a time and narrowed it down to the hood section of my bow quiver.
It's a six arrow strap on Boa quiver. I think the noise could be the tag end of the strap. That's the part that extends beyond the peg that secures the strap.
Before I go cutting this piece off has anyone had a similar experience? Could there be a source of noise other than the strap?
-
I had one that the strap was making noise, i cut it off. That may not be the case on yours, you might try securing the tag end with a rubber band or something before you cut
-
You don't have to cut it off. Instead, pull the strap off the quiver. Then snap it back in over the post using the hole that you used after wrapping around the bow. Then run the strap thru the quiver and then around the bow and the hole that was the "base" hole before should line up with the post. The little piece of strap that now extends will fit nicely against the quiver parts. (Change both quiver hood and arrow grabber.) It makes for a nice neat appearance. Terry