Trad Gang

Main Boards => PowWow => Topic started by: Coach Jones on August 12, 2015, 02:12:00 PM

Title: EFA Quiver
Post by: Coach Jones on August 12, 2015, 02:12:00 PM

Got my quiver today.  My only concern is that the screw inside the arrow gripper and hood where the quiver slides over the limb will rub on my bow.  I have the wrap model.   I puts some mole skin over the screw.  Hope it is adhesive enough to stick to the rubber.  Anyway I like the design.  Much smaller in profile than the GN Adjustable.    Got figure out how to lengthen the totem feature though.

Title: Re: EFA Quiver
Post by: Bill Turner on August 12, 2015, 02:28:00 PM

I've owned and used several EFA quivers without problems. I really like the totem with offset. You should be very happy with your purchase. Good luck and "Keep'Um Sharp".   :campfire:

Title: Re: EFA Quiver
Post by: kevsuperg on August 12, 2015, 02:51:00 PM

I have two of the 4 arrow wrap on models. The screw has never been an issue.
 I can't wrap em tight enough to get the screw to touch, bear grizzly and  HH Wesley special.

Title: Re: EFA Quiver
Post by: Coach Jones on August 12, 2015, 02:56:00 PM

Yep I see that now that I have it mounted.  Got the totem adjusted.  Looks good.

Title: Re: EFA Quiver
Post by: hart2hart on August 12, 2015, 08:29:00 PM

Coach,
If I copied the Totem correctly,just roll the surgical tubing back enough to ease the friction on the smaller tube.Slide out to desired length and then unroll.
Mike