Tapered aluminum what nocks?

[Jakeemt]

Got about 20 older 2216's in a swap but, I am unsure what nocks to use with them. They have a taper at the end and 11/32 nocks are two large 5/16 seem small though I could be wrong. Most of the nocks are old and I would like to replace them.

[Steelhead]

I believe I used 11/32 on the 2216 and 2219s I used  to shoot.Its been awhile

I used 5/16th on 2020s,2018s and 2016s

[Biathlonman]

Should be 11/32.

[Jakeemt]

Even with the taper? The shaft it's has about a 5 degree taper about two inches from the end before the silver cone for gluing the nock on.

[grouseshooter002]

I still shoot 2216 from two of my bows and "yes" the 11/32" nock is the correct one. When gluing twist the nock around the swag a time or two so the glue is evenly spread.

Grouse

[last arrow]

Some older al had a slight narrowing of the shaft just before the nock taper.  With those use 5/16.  Being small does not matter as long as it is aligned.

[Old Chief]

If you mean the shaft seems to step down, like the old autumn orange shafts, before the nock tapers begins, then they take a 5/16 nock.

[Hermon]

Originally posted by Old Chief:
If you mean the shaft seems to step down, like the old autumn orange shafts, before the nock tapers begins, then they take a 5/16 nock.

X2

[M60gunner]

X3

[Jakeemt]

Thank you guys that's what I was trying to say. 5/16 it is