3Rivers Archery



The Trad Gang Digital Market













Contribute to Trad Gang and Access the Classifieds!

Become a Trad Gang Sponsor!

Traditional Archery for Bowhunters






LEFT HAND BOWS CLASSIFIEDS TRAD GANG CLASSIFIEDS ACCESS RIGHT HAND BOWS CLASSIFIEDS


Author Topic: Tuning question  (Read 504 times)

Online Buckeye1977

  • Contributing Member
  • Trad Bowhunter
  • ****
  • Posts: 794
Tuning question
« on: August 10, 2017, 12:03:00 PM »
I'm shooting my Kwyk Styk which is 47@28 and my draw is about 26.5. Shooting gold tip trad .500's cut to 28.25" with a 2" aluminum footing and 175 grn point with standard insert. Seems to paper tune well other than a little nock high but I believe that is just my form. The arrows seem to fly straight out of the bow but don't always go where I'm looking. Sometimes I'll shoot 3 or 4 arrows right on the money and then one will impact 8" or so off target. Not sure if I'm doing something wrong in tuning or if the arrows might be too stiff. I had a bw plv at 50@28 and it shot the same arrow with a 250 grn point and put bullet holes through paper. Never seemed to have the flyers either. Any help is greatly appreciated. Thanks
Nick

PBS Associate member
JD Berry Viper 62” 50@28

Offline mwosborn

  • Trad Bowhunter
  • **
  • Posts: 1678
Re: Tuning question
« Reply #1 on: August 10, 2017, 01:37:00 PM »
When I have a "flier" it is normally my fault...break down in form.     ;)  

Once in a while you will get a "bad" arrow.  You could rule that out easy enough.  If the flier is always the same arrow it might have something going on with it.
Enjoy the hunt!  - Mitch

Offline Alexander Traditional

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 3696
Re: Tuning question
« Reply #2 on: August 10, 2017, 01:38:00 PM »
I would say stiff. Those .500 spine surprise me how stiff they got when cut down. I was using 300 up front with about 50@28. I started leaving mine full length,and found them much easier to tune.

Offline dbd870

  • Trad Bowhunter
  • **
  • Posts: 1086
Re: Tuning question
« Reply #3 on: August 11, 2017, 08:08:00 AM »
Yeah, I'm surprised they don't show stiff as well.
SWA Spyder

Offline Rick Richard

  • Trad Bowhunter
  • **
  • Posts: 1064
Re: Tuning question
« Reply #4 on: August 11, 2017, 08:16:00 AM »
Just because they shoot great through paper does not always mean they will impact where you are looking. I tune my arrows now based on how well they fly to the target and where they impact in reference to my aiming point.

Online Buckeye1977

  • Contributing Member
  • Trad Bowhunter
  • ****
  • Posts: 794
Re: Tuning question
« Reply #5 on: August 11, 2017, 08:50:00 AM »
Even when I bareshaft tuned they flew good and I was surprised I was able to get them to fly straight also. Think I might try some .600 spine and see if I can get them shooting better.
Nick

PBS Associate member
JD Berry Viper 62” 50@28

Offline bhylton

  • Trad Bowhunter
  • **
  • Posts: 31
Re: Tuning question
« Reply #6 on: August 11, 2017, 09:55:00 AM »
i found when cutting carbons there was a real critical length. they would start weak and i would trim, trim, trim to get them flying well. But if i took off 1/2in too much they would go stiff and no reasonable extra point weight would bring them back. is it always the same arrow that flys funny for you?

Online Buckeye1977

  • Contributing Member
  • Trad Bowhunter
  • ****
  • Posts: 794
Re: Tuning question
« Reply #7 on: August 11, 2017, 10:44:00 AM »
Haven't tried to narrow it down that far yet.
Nick

PBS Associate member
JD Berry Viper 62” 50@28

Offline longbow fanatic 1

  • Trad Bowhunter
  • **
  • Posts: 2312
Re: Tuning question
« Reply #8 on: August 11, 2017, 01:59:00 PM »
If they paper tune fine and you put three to four right on the money and then have an occasional flier, It's most likely a form issue.

Online Buckeye1977

  • Contributing Member
  • Trad Bowhunter
  • ****
  • Posts: 794
Re: Tuning question
« Reply #9 on: August 11, 2017, 05:33:00 PM »
I'm hoping that's the case but just not used to Shooting as bad as I have been lately. Going to do some further investigation to see if I can figure out what's going on
Nick

PBS Associate member
JD Berry Viper 62” 50@28

Offline mahantango

  • Trad Bowhunter
  • **
  • Posts: 1384
Re: Tuning question
« Reply #10 on: August 11, 2017, 07:38:00 PM »
Ok, so your bow is 47#@28" and your draw is 26.5". You are getting 43-44# at best, so I would say those .500s are stiff - especially cut to 28.5". I shoot .500s out of 55-60#.
We are all here because we are not all there.

Offline rjackson

  • Trad Bowhunter
  • **
  • Posts: 612
Re: Tuning question
« Reply #11 on: August 11, 2017, 08:26:00 PM »
Nick, is you Kwyk styk have static or regular recurve limbs? I have static limbs on mine and it likes a stiff arrow.

Check and see if it's the same arrow.

Randy

Online Buckeye1977

  • Contributing Member
  • Trad Bowhunter
  • ****
  • Posts: 794
Re: Tuning question
« Reply #12 on: August 11, 2017, 08:31:00 PM »
I'm gonna get some .600's and give them a try and see what I come up with. I had the .500's already and wanted to give them a go before I bought new shafts but gonna get a few and try them. Thanks
Nick

PBS Associate member
JD Berry Viper 62” 50@28

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2024 ~ Trad Gang.com ©