INFO: Trad Archery for Bowhunters



« previous next »
Pages: [1]   Go Down

Author Topic: Bear Mag TD Machine screw size ??  (Read 971 times)

Offline TRAP

  • Trad Bowhunter
  • **
  • Posts: 2747
Bear Mag TD Machine screw size ??
« on: September 15, 2015, 12:40:00 AM »
Can someone tell me the size designation of the Phillips head Machine screws that anchor the sight plate and the adjustable side plate? How about a source?

Thanks in advance, Daryl
Logged
"If you don't like change, you're going to like irrelevance even less" Gen. Eric Shinsheki

"If you laugh, and you think, and you cry, that's a full day, that's a heck of a day." Jim Valvano.

Offline inrut

  • Trad Bowhunter
  • **
  • Posts: 167
Re: Bear Mag TD Machine screw size ??
« Reply #1 on: September 15, 2015, 07:06:00 AM »
I sent you an e-mail
Logged

Offline TRAP

  • Trad Bowhunter
  • **
  • Posts: 2747
Re: Bear Mag TD Machine screw size ??
« Reply #2 on: September 15, 2015, 10:30:00 AM »
Monte,

not sure what happened but I didnt get an email.

Thanks, Daryl
Logged
"If you don't like change, you're going to like irrelevance even less" Gen. Eric Shinsheki

"If you laugh, and you think, and you cry, that's a full day, that's a heck of a day." Jim Valvano.

Offline TRAP

  • Trad Bowhunter
  • **
  • Posts: 2747
Re: Bear Mag TD Machine screw size ??
« Reply #3 on: September 15, 2015, 10:42:00 AM »
guess the word "screws" kicked the email into spam   :saywhat:

Thanks for your response.

DD
Logged
"If you don't like change, you're going to like irrelevance even less" Gen. Eric Shinsheki

"If you laugh, and you think, and you cry, that's a full day, that's a heck of a day." Jim Valvano.

Online twigflicker

  • TGMM Member
  • Trad Bowhunter
  • ***
  • Posts: 513
Re: Bear Mag TD Machine screw size ??
« Reply #4 on: September 15, 2015, 01:01:00 PM »
Too funny Trap...

Monte's the man on the mag risers...

Jonathan
Logged
TGMM - Family of the Bow
PBS Associate
Pages: [1]   Go Up
« previous next »

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2024 ~ Trad Gang.com ©