silver inlay

[theunluckyhunter]

any/all of you that do it, would you mind posting some pictures and measurements of your tools? also some of the supply shops? i decided it's time for a try at it

[Steve Nuckels]

A small hammer,file, too large a pair of side cutters, three chisels total and some brass wire for the first time out.  The chisles were made from hack saw blade that one of our fellow Ganger's hooked me up with!  

I plan to get some silver wire soon.  A pair of magnifying grasses would be helpful too.


 640 Pixels maximum width.  VM13

[theunluckyhunter]

what are the file and side cutters for?

do you just use the different width chisels at an angle to cut the channel? also is the wire just held in by friction or do you glue it in?

[theunluckyhunter]

steve, can you pm me your number?

[Jeremy]

The side cutters are to cut the bezel wire to length.  The different width chisels are held perpendicular to the handle surface when used.  You choose the chisel width you use based on the radius of the curve you're trying to make.  Pick a chisel, put it on your line and push or tap it into the wood.  Pull it out, move it down the line and repeat, making sure to overlap your previous cut.

I still cringe when I see those hacksaw chisels, but they do work very well and you can't beat the price!  

[mwmwmb]

I have been thinking about this as well. what gauge wire do you use.

[theunluckyhunter]

the wire is flat

[mwmwmb]

is it a specialty item or can you get it at hardware stores?

[theunluckyhunter]

you can get it from jewelry supply houses i believe.....

[Jeremy]

The flat wire is called bezel wire and is available at jewelery supply places online.

Check out the "features" section of  www.blademag.com  for step by step instructions.