Antler and damascus drop point.

[skullworks]

Here is one I just finished. Damascus drop point with stabilized and dyed whitetail antler. The spacer is buckeye burl and rust red spacer material with a brass guard. The blade is apprx 3-1/2" and OAL is between 8-1/2" and 9". Enjoy!

 

[p1choco]

I've been browsing this knife section for the past week.  You put out some nice lookin stuff!  Often!  I'm jealous.

[Big Riser]

NICE KNIFE love those drop points.Made one my self today. I have a sawmill so I used some walnut I cut a year ago.Made the blade out of a buss saw blade. Would like to make one with a stag handle. HOW DID YOU ATTACH YOUR HANDLE?
                 Thanks         Frank

[skullworks]

Originally posted by Big Riser:
NICE KNIFE love those drop points.Made one my self today. I have a sawmill so I used some walnut I cut a year ago.Made the blade out of a buss saw blade. Would like to make one with a stag handle. HOW DID YOU ATTACH YOUR HANDLE?
                 Thanks         Frank

West Marine epoxy and sometimes a pin.

[Big Riser]

Thanks skullworks Ill give that a try .and again you make some nice knifes.

[skullworks]

Originally posted by Big Riser:
Thanks skullworks Ill give that a try .and again you make some nice knifes.

Just make sure you cut some notches in the tang of the knife to give the epoxy better holding power. Devcon 2 ton epoxy is good also. Thanks for the compliment!