INFO: Trad Archery for Bowhunters



« previous next »
Pages: [1]   Go Down

Author Topic: Finishing horn how to?  (Read 439 times)

Offline elk ninja

  • Trad Bowhunter
  • **
  • Posts: 1024
Finishing horn how to?
« on: December 26, 2011, 02:09:00 PM »
I have a couple little capers I am getting ready to finish up, they have sheeps horn, the first time I have used it.  

But I am not sure how to finish them up.

Sand to 600 then mineral oil?  Same finish as wood?  

How have you experienced gurus done it?
Logged
>>>--Semper-Fi--->

It is better to remain silent and be thought a fool than to open one's mouth and remove all doubt.
-Abraham Lincoln

Offline Lin Rhea

  • Trad Bowhunter
  • **
  • Posts: 4541
Re: Finishing horn how to?
« Reply #1 on: December 26, 2011, 02:16:00 PM »
It depends on the surface texture. If the rough has been ground away and it's all smooth, just wax it. I dont take any pains to treat Sheep horn with anything. I might wax it but I dont want to get the wax into the rough areas. It makes a mess. It served the Sheep well as is so I figure it most likely dont need much.
Logged
"We dont rent pigs." Augustus McCrae
ABS Master Bladesmith
TGMM Family of the Bow
Dwyer Dauntless longbow 50 @ 28
Ben Pearson recurve 50 @ 28
Tall Tines Recurve 47@28
McCullough Griffin longbow 43@28
Pages: [1]   Go Up
« previous next »

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2024 ~ Trad Gang.com ©