Glue-on adapter with additional weight for carbon shafts?

[Naphtali]

I have been nickel-dicking with a broadhead manufacturer for two years with nothing to show for it. So it's time to move on.

Carbon arrows I have bought all have had screw-in inserts and three right-hand helical vanes. I want to be able to use Grizzly El Grande broadheads as glue-ons.

1. Does any carbon/Kevlar® arrow manufacturer offer arrows with glue-on inserts appropriate for El Grandes?

2. Where can I buy appropriate glue-on inserts for existing arrows? And how do I remove screw-in inserts without destroying the carbon shafts?

3. Are glue-on inserts available that include the extra 50 or 100 grains of conventional brass inserts?

4. If nothing comes easily, please recommend an arrow maker or vendor who can make 4-fletch carbon/Kevlar® arrows as I am requesting.

[Kingstaken]

Many sponsers have what your lQQking for. Here a link I was just lQQking at myself for Bob Lee Archery. See the bottom of the page.

 http://www.bobleearchery.com/index.php?crn=281

Good Luck.

[BobW]

Is this what you are looking for?

 http://www.3riversarchery.com/Product.asp?c=57&s=47&p=258&i=4930

[hickstick]

pretty much all trad dealers sell 75 & 100 grain glue on adaptors.  AFA the fletch...if you need the opposite that they come with, strip them off (razor knife held flat against the shaft).

also..to remove the aluminum inserts already glued into the shafts...what you need to do is screw in a field point you don't mind loosing to mares or heat.   then heat ONLY the field point with a torch (I use the burner on my gas stove)...the I hold the shaft with something non slip (like the underside of a mouse pad - same pad I use for applying wraps), grab the field point with pliers or vise grips and pull....

gotta be careful no to apply the flame directly to the shaft, and not to indirectly heat the shaft too much.  then once the inserts are removed and shafts are cool....you gotta sand paper the inside of the shaft to smooth out any residual glue... and clean the inside out before gluing in your new inserts in....

[BobW]

Removal via "swing hammer".  It takes too long to type, so do a search for "drill bit".

BobW