urac and not going back

[trentcur]

used urac on this bow and will not be going back to titebond...... I know TB works fine but I am way more confident in the urac..... it worked perfectly. It also helped that I finally built my heat box...... so the glue could cure in something other than a cold garage (that was probably as much of a problem as anything!).

Anyway started the kids bow to replace my shattered one...... this ine 50" long maple backed maple with ERC handle and tip overlays. Ill see if I cant get her tillered tomorrow. Floor tillered at the moment.
 
 
 

[Stiks-n-Strings]

urac is some good stuff

[Roy from Pa]

Atta boy.. URAC is the best wood to wood glue in my opinion. But what the heck does an old fart know?

[fujimo]

a fair amount- apparently!!
 nice bows you guys all build.
i would be sure to scour up the two surfaces with a toothing plane( or i use a sawzall blade).
and then dont over clamp and get a glue starved joint- the grooves help with that some- besides increasing the glue contact surface area.
its great glue- so user friendly- and water clean up- great worktime etc.