Author Topic: Thoughts about sinew backed bows  (Read 325 times)

Offline LittleBen

  • Trad Bowhunter
  • **
  • Posts: 2970
Thoughts about sinew backed bows
« on: February 26, 2013, 09:13:00 PM »
Hey everyone,

I'm working on a sinew backed Eastern Red Cedar bow, it's 58" tip to tip, and 2" wide at the fades. Recurved tips (3" total reflex or so). Just glued on some thin hickory underlays to enhance the curve and stiffen.

It got me thinking, maybe it'd make a better bow if I add full length belly lamination of hickory after I get this thing tillered to say 10-15# below the desired draw weight.

I was trying to get 60# or so out of this thing and I'm having doubts about whether the ERC will stand up to it. I thoutht the hickory would be stronger and unlikely to chrysal with sinew as backing.

Any thoughts are appreciated.

Online Pat B

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 15019
Re: Thoughts about sinew backed bows
« Reply #1 on: February 26, 2013, 11:26:00 PM »
ERC is a lot stronger in compression than hickory. It is the tension side of ERC that is unpredictable but the sinew backing should take care of that. I think ERC and sinew are a good match.   Tiller your ERC out to the ultimate weight then sinew back it. After the sinew is completely cured retiller the bow to your desired weight.
Make the most of all that comes and the least of all that goes!
TGMM Family of the Bow

Offline LittleBen

  • Trad Bowhunter
  • **
  • Posts: 2970
Re: Thoughts about sinew backed bows
« Reply #2 on: February 27, 2013, 08:44:00 AM »
Sounds good pat, although I think I will have to sinew back first, at least one layer because the stave is severly decrowned and not the cleanest looking back. Some ring violation and a few pinholes etc.

Hopefully I didn't do a stupid thing by adding tip iunderlays, the tips were just so thin they were never going to hold up to more than 30 lbs. I guess worst case I could grind the hickory inderlays off and laminated some ERC on there.

Offline snakewood3

  • Tradbowhunter
  • Trad Bowhunter
  • *
  • Posts: 1093
Re: Thoughts about sinew backed bows
« Reply #3 on: February 27, 2013, 08:51:00 AM »
A little tip on ERC / juniper...bone the belly and sides with a fair amount of pressure. This will greatly improve the resistance to damage and might have some other benefits regarding shooting qualities as well.
U.S. Navy Seabees '79 - '86
Custom knives and leatherwork

Offline LittleBen

  • Trad Bowhunter
  • **
  • Posts: 2970
Re: Thoughts about sinew backed bows
« Reply #4 on: February 27, 2013, 09:31:00 AM »
thanks! will do.

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2024 ~ Trad Gang.com ©