Riser duplication how do you do it.

[BrushWolf]

I currently use a sander and rasp but it takes atoll on the hands.  So how do you all do it mainly for the grips.

[Crooked Stic]

Spindle sander and calipers. after a few you get the knack.

[SportHunter]

I've seen some use hand held spindle sanders. Been thinking of adding one to the kit.

[BrushWolf]

I use a drum sander in a drill some it does help a lot.

[kennym]

I used this on the last bow , bocote riser, didn't plug up much and I bet if I ran it in reverse on some maple it would clean right out.

Its a tire repair tool for grinding before the patch. Think it was less than 5 bucks when I bought it several years back,wish I'd tried it sooner.

I put a carriage bolt in it with a washer and nut to hold it.

Run it slow or fast, no prob and it really shapes stuff. I imagine it would shape fingers too, so be careful if you try it!   :D  

   

[BrushWolf]

That's  pretty  neat right there Kenny it sure would save on sand paper. Thanks for the tip.