« previous next »
Pages: 1 [2]   Go Down

Author Topic: SCARF JOINT HELP  (Read 2386 times)

Offline Flem

  • Trad Bowhunter
  • **
  • Posts: 2985
  • "Don't quote me on that!"
Re: SCARF JOINT HELP
« Reply #20 on: September 03, 2021, 03:38:44 PM »
In the spirit of the OP, here is another way to get your scarf if you have a table saw, but not a disc sander.
Using the miter gauge slot, I get a 13/16" lap on .200" lams
Logged

Online Jeff Freeman

  • Trad Bowhunter
  • **
  • Posts: 392
  • Just a Hobby, gotta keep it fun 🏹
Re: SCARF JOINT HELP
« Reply #21 on: September 03, 2021, 05:46:56 PM »
Is this knife big enough 🤣
Logged
🦌🏹😃

Online Mad Max

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 6565
Re: SCARF JOINT HELP
« Reply #22 on: September 03, 2021, 05:59:30 PM »
No mate you got to have a crocodile dundee knife
Logged
I would rather fail at something above my means, than to succeed at something  beneath my means  
}}}}===============>>

Online Jeff Freeman

  • Trad Bowhunter
  • **
  • Posts: 392
  • Just a Hobby, gotta keep it fun 🏹
Re: SCARF JOINT HELP
« Reply #23 on: September 03, 2021, 06:00:38 PM »
Dam yours is bigger 😅
Logged
🦌🏹😃

Offline Mike L.

  • Trad Bowhunter
  • **
  • Posts: 214
Re: SCARF JOINT HELP
« Reply #24 on: November 18, 2021, 02:38:56 PM »
I always have a hell of a time using my disc sander for scarf joints.  I can’t seem to get it to sand a taper 90 degrees.
Logged
Mike L.

Online Jeff Freeman

  • Trad Bowhunter
  • **
  • Posts: 392
  • Just a Hobby, gotta keep it fun 🏹
Re: SCARF JOINT HELP
« Reply #25 on: November 18, 2021, 03:26:28 PM »
How the heck did that knife get in this post, I'm confused. I think I have a picture of my jig for scarfing the joints. JF
Logged
🦌🏹😃
Pages: 1 [2]   Go Up
« previous next »

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2024 ~ Trad Gang.com ©