Shrew and MFX advice needed

[cgeiser]

I've got a 58# @ 28" Super Shrew coming. I'm looking to get some arrows to test out with it. I draw to 29" so I'm assuming about 61#. I'd like to keep point weight somewhere between 225 and 325. Any advice on which spine of MFX classic?

Thanks for any tips you can give!

Che

[Hamish]

The 340 would be the go.

[Ray Lyon]

I draw 28 3/4 with my Super Shrew Samurai and I'm at 59# at my draw.  I shoot the 400's cut to 29.5 with 200 grain points.

[HATCHCHASER]

400's or 340's should work.  You may have to leave the 340's a little longer.

[cgeiser]

Thanks for the advice guys. Sounds like I'm right on the edge.

I need to make a small correction to my original post. The bow is 56@28 so about 59 at my draw. So maybe 400's are right?

Thanks again,
Che

[archenemy]

I shoot about 56# at 29.5' draw.  I use the 400's with 100 grain brass insert, 125 and 145 grain heads.  I've even used 175 grain heads with lots of arch to the shot.

Archenemy

[archenemy]

Ha, I meant 29.5" not feet!

[hunt it]

I shoot 400's (29.5")out of my 64# all the time with 300gr up front. These same arrows fly superbly out of my 54# as well.

[ISP 5353]

My set up is exactly like Ray Lyon's.  Same specs and all.

[bayoulongbowman]

vaporwood 3000 would work too.......

[eagle24]

I'd be real surprised if the 400's were'nt stiff enough.

[Pat B.]

Hey, call 3 rivers and get one of their test kits if they still have 'em... You'd get 2 of each size shaft. Then you could figure out what works for you..  For me, it would be the 340's, I must have a crumby release !!