Bitzenburger Fletching Jig Instructions? / Question

[jcar315]

I have several Bitzenburger fletching jigs. They work great but I have a question: I picked them up used and they are set up for 3 fletch but was curious how to change the "setting" to do 4 fletch? Does anyone have instructions that they could email me? If no instructions could you give me the "skinny" on how to do it here? Thanks so much.

[joe skipp]

On the nock receiver end, you will notice 3 small set screws. Alongside the screws are the degree you can fletch. The top screw is for 3 fletch, the middle and bottom screw are 4 fletch.
Bring the set screw UP for the one your NOT using and screw down the one you want to use. You should notice 2 different degrees you can 4 fletch with.

[moebow]

On my Bitz's The top one is 120 - 3 fletch.  The middle one is 90 - 4 fletch at 90 degrees and the bottom one is 75/105 four fletch.  What Joe Skip explaned is correct.

[jcar315]

You guys are the best! Thanks.

[rraming]

I sent you the manual

[jcar315]

Thanks Rich!!

[snag]

If it is possible I'd love to receive the manual as well...? I just bought some Bitz jigs and have never used them before.  David

[jcar315]

David, give me your email and I will email you the manual that Rich sent me!!!