Author Topic: Shelf angled down to riser (Read 293 times)

xtrema312 · « **on:** February 06, 2010, 10:59:00 PM »

What is the purpose of a shelf cut angling down to the riser face? I assume to keep the arrow on the shelf, but doesn't it cause the arrow to hit the shelf edge? How does this work?

R H Clark · « **Reply #1 on:** February 07, 2010, 12:39:00 AM »

IMHO if it is not too extreme it shouldn't give paradox clearence problems with a properly spined arrow but it could cause a strike on borderline spined or tuned arrows.

owlbait · « **Reply #2 on:** February 07, 2010, 10:57:00 AM »

I would think with a shelf pad and sideplate it would not be a problem. You may even get less shaft contack , especially if you leave a small valley between the rest pad and the side plate.

Bjorn · « **Reply #3 on:** February 07, 2010, 11:05:00 AM »

An arrow will clear off to the edge of the shelf.
If there is any contact the edge will screw things up; I would make sure the bottom of the shaft is above that edge so it can pass freely.

News:

Author Topic: Shelf angled down to riser (Read 293 times)

xtrema312

Shelf angled down to riser

R H Clark

Re: Shelf angled down to riser

owlbait

Re: Shelf angled down to riser

Bjorn

Re: Shelf angled down to riser

Users currently browsing this topic:


LEFT HAND BOWS CLASSIFIEDS	TRAD GANG CLASSIFIEDS ACCESS	RIGHT HAND BOWS CLASSIFIEDS