Think I decided... (aluminum arrows...again)

[dave19113]

Originally posted by Rob DiStefano:
i used a mini tubing cutter on alums for over 30 years with nary a problem on over 10 dozen alums from 24srt-x to x7.  don't need no chopping saw, save yer money.

Id go with wat Rob said..... Ive used one for years and it worked great. I do admit i bought an electric arrow cutter. But honestly I bought it bc I wanted something else to buy....

Good Luck

[Terry Riley]

I just buy a sheet of mylar decal material at the hobby shop. Comes in a large variety of bright colors. I cut the width to the circumference of the arrow shaft I'm using. Less than $5 for a large sheet of the stuff.

Terry

[Night Wing]

I've used a small tube cutter to cut all of my aluminum shafts to my preferred 32" length for four decades.

[Bob L.]

sent you a pm

[varmint101]

Originally posted by joe skipp:
OK Varmint...will be sending you an application for Team Pink...Great looking arras....            

lol, thanks.

[Bill Turner]

I've used a mini-tube cutter as well without problem. If you happen to have a RCBS deburring tool, that you use when reloading pistol and rifle ammo, it also works well when deburring aluminum shafts.