3Rivers Archery



The Trad Gang Digital Market













Contribute to Trad Gang and Access the Classifieds!

Become a Trad Gang Sponsor!

Traditional Archery for Bowhunters






LEFT HAND BOWS CLASSIFIEDS TRAD GANG CLASSIFIEDS ACCESS RIGHT HAND BOWS CLASSIFIEDS


Author Topic: repeated stringing and un stringing  (Read 416 times)

Offline Bowwild

  • TG HALL OF FAME
  • Trad Bowhunter
  • *****
  • Posts: 5433
Re: repeated stringing and un stringing
« Reply #20 on: June 24, 2010, 09:42:00 PM »
I talked to the bowyers about this. As a result I only unstring my recurves if I need to change strings, brace height, or add silencers. Like others have written, danger of limb twist even when using stringer is far greater than damage by leaving strung.  If I know I'm not going to shoot a bow for months, I unstring it also.  Right now 3 of my 9 recurves are unstrung as is my only "uncurve".

Offline yaderehey

  • Trad Bowhunter
  • **
  • Posts: 248
Re: repeated stringing and un stringing
« Reply #21 on: June 25, 2010, 12:37:00 AM »
I remember reading that Bear Archery studied this and left some of their bows strung for 2 years and then checked to see how much draw weight was lost.  The average was 1-2 pounds loss.  The kicker was after these bows were unstrung for a few days all the lost draw weight came back.  As I recall their determination was that no harm came in leaving a bow strung and otherwise handled and stored properly.  I personally leave those bows I'm shooting regularly strung and if I'm not shooting a particular bow much it's unstrung.

Offline ArrowCrester

  • Trad Bowhunter
  • **
  • Posts: 130
Re: repeated stringing and un stringing
« Reply #22 on: September 02, 2010, 01:10:00 AM »
I have a Fred Bear Kodiak T/D recurve. Instructions that came with the bow sez:

Your bow may be left struck for a week or so, but for longer periods the string should be removed. hang the bow vertically with the lower limb off the floor or placed horizontal across two pegs.


Yes best to use a stringer.

   :archer2:    :archer2:    :archer2:
Yours In BowHunting,

Bob

Offline JRY309

  • Trad Bowhunter
  • **
  • Posts: 4383
Re: repeated stringing and un stringing
« Reply #23 on: September 02, 2010, 12:18:00 PM »
If I'm shooting a bow regularly I don't unstring,but don't leave in heat or laying out in direct sunlight.

Offline Northwoods

  • Trad Bowhunter
  • **
  • Posts: 117
Re: repeated stringing and un stringing
« Reply #24 on: September 02, 2010, 02:03:00 PM »
I unstring my self bow after shooting daily and haven't had any problems in the 6 yrs I've owned this bow.
Be strong and of good courage, do not be afraid or be dismayed for the Lord your God is with you wherever you go - Joshua 1:9

Offline KEG

  • Trad Bowhunter
  • **
  • Posts: 163
Re: repeated stringing and un stringing
« Reply #25 on: September 03, 2010, 12:10:00 AM »
I'll leave mine strung if I am shooting regularly. I usually keep my bow in the garage, but now bring it inside the house since it is hot outside. I do unstring and restring my bow if I travel with it.

Offline jim phenes

  • Trad Bowhunter
  • **
  • Posts: 75
Re: repeated stringing and un stringing
« Reply #26 on: September 03, 2010, 12:48:00 AM »
i unstring mine every time im done its a bear montana long bow but after reading the input i may leave it strung through the day and unstring at night!

Offline motorhead7963

  • Trad Bowhunter
  • **
  • Posts: 374
Re: repeated stringing and un stringing
« Reply #27 on: September 03, 2010, 01:00:00 AM »
just a thought........ the act of shooting your bow is probably five times as much work on the bow as stringing and unstringing, I would think if your shooting that frequently I'd say your adding more work than needed??!!!

Offline Night Wing

  • Trad Bowhunter
  • **
  • Posts: 2944
Re: repeated stringing and un stringing
« Reply #28 on: September 03, 2010, 01:37:00 AM »
My two take down recurve bows stay strung all the time. Only unstring them if the brace height changes or I need to replace the bowstrings.
Blacktail TD Recurve: 66", 42# @ 30". Arrow: 32", 2212. PW: 75 Grains. AW: 421 Grains. GPP: 10.02
Blacktail TD Recurve: 66", 37# @ 30". Arrow: 32", 2212. PW: 75 Grains. AW: 421 Grains. GPP: 11.37

Offline Dave Bulla

  • Trad Bowhunter
  • **
  • Posts: 1794
Re: repeated stringing and un stringing
« Reply #29 on: September 03, 2010, 02:15:00 AM »
I always unstring my bows when not in use.  I push pull string and unstring all my longbows and even my recurves up to about 50 or 55#.  Above that, recurves are tougher but I don't own any I can't string.  With longbows, if I can shoot it, I can push pull string it.

I know I've read of people keeping recurves strung for years at a time and measuring weight and finding zero or extremely minimal weight loss so it must not hurt them but I just can't bring myself to leave them strung.  Part of that is because my bow rack has pegs about 6 inches apart and a strung bow would interfere with the other bows but the other part is just a belief that constant strain for long periods of time has to cause SOME effect.

Either way, the entire stringing or unstringing operation only takes me about 3 to 5 seconds so why worry about it.
Dave


I've come to believe that the keys to shooting well for me are good form, trusting the bow to do all the work, and having the confidence in the bow and myself to remain motionless and relaxed at release until the arrow hits the mark.

Offline Don Stokes

  • Tradbowhunter
  • Trad Bowhunter
  • *
  • Posts: 2607
Re: repeated stringing and un stringing
« Reply #30 on: September 03, 2010, 08:48:00 AM »
Dave, I hope you're wearing safety glasses when you push/pull a recurve!! That's an excellent way to lose an eye. It's happened before, too many times!!

You should always use a stringer on a recurve, if you value your eyes.
Those who would give up essential liberty to purchase a little temporary safety deserve neither liberty nor safety.- Ben Franklin

Offline Old York

  • Trad Bowhunter
  • **
  • Posts: 577
Re: repeated stringing and un stringing
« Reply #31 on: September 03, 2010, 08:55:00 AM »
I string & unstring my recurve religiously, otherwise I'd forget how it's done   ;)  

Always use a stringer on a recurve   :thumbsup:
"We were arguing about brace-height tuning and then a fistmele broke out"

Users currently browsing this topic:

0 Members and 1 Guest are viewing this topic.
 

Contact Us | Trad Gang.com © | User Agreement

Copyright 2003 thru 2024 ~ Trad Gang.com ©