Author Topic: Removing Easton Logo (Read 195 times)

acollins · « **on:** November 10, 2011, 03:59:00 PM »

I am wanting to remove the gray Easton logo on my XX75 arrows because my wraps are going to cover up part of it. I tried Acetone and it just lightened it up but did not remove it. What else could i try that wont damage the black under the logo.
Thanks

Recurve50 LBS · « **Reply #1 on:** November 10, 2011, 05:18:00 PM »

Try fine steel wool with denatured alcohol.

lil red rooster · « **Reply #2 on:** November 10, 2011, 06:02:00 PM »

Paint stripper works well for removing logos. It normally will not mess with the clear coat on the shaft. I have used it on Easton carbon arrows, but not the aluminum.

AdAstraAiroh · « **Reply #3 on:** November 10, 2011, 06:08:00 PM »

I succesfully used fingernail polish remover to clean off badly smudged logos on Gold Tip Traditionals.

Mark

lpcjon2 · « **Reply #4 on:** November 10, 2011, 06:21:00 PM »

Green scratch pad and lighter fluid works.

acollins · « **Reply #5 on:** November 10, 2011, 06:31:00 PM »

Thanks guys several good ideas i am sure one will work.

sticbow · « **Reply #6 on:** November 10, 2011, 10:07:00 PM »

0000 steel wool works all by itself for me..goldtips too..

News:

Author Topic: Removing Easton Logo (Read 195 times)

acollins

Removing Easton Logo

Recurve50 LBS

Re: Removing Easton Logo

lil red rooster

Re: Removing Easton Logo

AdAstraAiroh

Re: Removing Easton Logo

lpcjon2

Re: Removing Easton Logo

acollins

Re: Removing Easton Logo

sticbow

Re: Removing Easton Logo

Users currently browsing this topic:


LEFT HAND BOWS CLASSIFIEDS	TRAD GANG CLASSIFIEDS ACCESS	RIGHT HAND BOWS CLASSIFIEDS