10k rpm Grinder for Cutting Carbon - Good to Go?

[JJB2]

All you do-it-yourself carbon cutters out there...

I have a hand grinder rated at 10,000 rpms.  With a diamond blade and the grinder mounted square I should be good to go with cutting carbon arrows, right?  

Also, any good home build ideas for an arrow saw using the hand tool would be appreciated.

Thanks!

[Pete W]

Use a ZIP cut  blade.
 Before the first arrow is cut do a cut on steel to put a smooth edge on the Zip blade.

[overbo]

Small set of pipe cutters and a electric drill for me.

[JRY309]

A key to getting a square cut is being able to rotate the shaft as you cut.I made an inexpensive jig with a Harbor Freight mini chop saw.I mounted it on a board and made an adjustable stop block for repeatable cuts.On the stop block for the nock end I drilled a taper hole in it with a chamfer bit.This keeps the nock end from side to side movement and allows me to rotate the arrow shaft as I cut.I'll bring the blade just into the shaft and then rotate the shaft as I cut.This will give you a square cut.That is how the more expensive saws cut,they only have a small portion of the blade exposed so you have to rotate the arrow shaft as you cut.I have around $30 in my home cut-off saw,works great and have cut many dozen carbon and aluminum arrows for myself and friends.