It does take a little investing to get good quality products. Aluminum and carbon, would suggest an arrow cut off tool. Cuts them clean and accurately.
Personally, I would invest in 3 Bitzenbergers either RW or LW Helical. AMG or Trueflight feathers from a Sponsor here along with your glue and possibly stains.
I use 91% Isopropyl to clean my shafts. If your not going to crown dip/apply arrow wraps, then pick out a color stain you like and seal your shafts with Minwax Poly (Wood shafts only). For wood/aluminum, I prefer Snap on nocks. Carbon shafts come with nocks.
I'm old school...still crown dip all my arrows with Bohning products and use Bohning glue. Hot melt for inserts/points/broadheads. Carbon/Aluminum I like JB Weld 6 hr cure for inserts.
Again, from a good nock/point taper tool to all your building needs can be had right here from a good Sponsor.