Author Topic: Fitting Bear Limbs (Read 304 times)

Onehair · « **on:** March 03, 2014, 11:48:00 AM »

I recently traded for a set of limbs and the bottom just don't fit the riser correctly. It takes a lot of effort to get it far enough in the socket to seat the pin and close the latch. No obstructions in the way. Any quick fixes ?

Kip · « **Reply #1 on:** March 03, 2014, 11:56:00 AM »

Take the screw /pin out not needed.It was put in so as not to mix up top and bottom limbs.I read that on a post some time before.

M60gunner · « **Reply #2 on:** March 03, 2014, 11:56:00 AM »

The pin you are referring to, is it the locator pin? If so try removing it. I had to remove the pins on my mag. riser to get my newer limbs to seat in it.

Onehair · « **Reply #3 on:** March 03, 2014, 01:52:00 PM »

I'll do that. Thanks

News:

Author Topic: Fitting Bear Limbs (Read 304 times)

Onehair

Fitting Bear Limbs

Kip

Re: Fitting Bear Limbs

M60gunner

Re: Fitting Bear Limbs

Onehair

Re: Fitting Bear Limbs

Users currently browsing this topic:


LEFT HAND BOWS CLASSIFIEDS	TRAD GANG CLASSIFIEDS ACCESS	RIGHT HAND BOWS CLASSIFIEDS