KME Knife Sharpener on Single Bevel Heads

[swwifty]

Where's a good place to get a extra extra course diamond stone? The ones that came with the KME are also not very wide, which makes sharpening tough with the Grizzly single bevel broadheads. Any suggestions?

Thanks.

[R. W. Mackey]

Swiftly,  just do an Internet search for Diamond Sharpening
Stones, you will find several places that sells them. Most are made by DMT, but not all charge the same.

RW

[Bill Turner]

You can't beat Ron for hands on instruction. Great guy and well worth the call. Don't hesitate, just do it.  

[Steve O]

Originally posted by maxwell:
Remember you are only trying to get the very edge sharp not the whole bevel.  With the old grizzly's I used a file first to get the bevel manageable.

Best advice on the whole thread. I spent a LOT of time before realizing this ^^^^^^^^

[motorhead7963]

Holy crap, I am glad I found this thread I was about to gather up all my grizzlies and sell them. Just before Christmas I set up my KME to work on my grizzlies and I kept working and working and it seemed I was going no where. I have a dozen of the black 170s and thought I would see what I could do with them, first I couldn't get enough angle, so I just dealt with it and kept at it, finally got full contact on the edge but still cant get it sharp. It was just yesterday I picked up the whole setup and put everything away, I was actually going to list them in the classifieds because I was pretty much done trying to get any where. Now that I know to change the angle to 25deg, I will have to figure out how to accomplish that with a file. Good thread.

[Steve O]

This one over in the "How to" section by JimB is really good too:

   Sharpening