Green Stripe medallion question

[Orion]

How is the medallion attached to Green Stripe Bear TD risers.  Just epoxied on the surface, inletted, some sort of screw/ friction fit plug, etc. ?

I'm going to add a quiver insert and the medallion is located just about exactly where I would like to put it. Hoping to figure out a way where the medallion might cover the insert when not in use.

Can install the insert above the medallion, but would look a little busy there.

[papabear08]

Should just be on a friction post so there is a small hole there already when you remove it.

[Orion]

Any advice as to how to remove it without damaging it?  Any tool that will grab the edge of the coin or that I can work under it to pry it out, if that's the way to go?

[vintage-bears]

Dental floss around the medallion.

Keep easy upward pulling as you go round and round the medallion.
It will come out.

[Orion]

Thanks, Phil.  I'll give that a try. Does itv make any difference whether I go clockwise or counter-clockwise?

[Orion]

Wait a minute.  I think I misunderstood your initial advice.  Think I have it now.  Work the string under the medallion and pull. Thanks.

[highlife]

Consider going back with something other than the cheap plastic medallion ... here is what I did to mine.

I embedded an old Waltham wrist compass which was issued to all WW2 pilots to help them navigate there way back behind enemy lines if shot down.

 [/url] [/IMG]

[highlife]

Here is the shelf side ... I ended up lowering the shelf by 5/8" and putting a nice radius on it for good arrow flight.  [/url] [/IMG]

[papabear08]

Great idea and look !!