another slip joint

[D.Ellis]

Finished this one up today.
Interior mammoth, O-1 steel with ferric chloride etch. Nickel silver pins, shield and liners......bronze "washer"
4 1/8" closed......3 1/4" blade.  Half stop. Good walk and talk, and flush in all three positions. Shield is pinned.
Comments and critique are welcome as always.

Darcy    

 

 

 

 

 

[Doug Campbell]

Very nice Darcy, I like that a lot.            Wish I had time to play with some slip joints...

[frank bullitt]

Yes, very nice!    

I think anyone would love to carry and use that!

[Roughcountry]

I like that one a bunch    Can I ask what you put the thumb nick in with?
I struggle with those.

[just_a_hunter]

A real handy beauty.

Todd

[D.Ellis]

Originally posted by Roughcountry:
I like that one a bunch       Can I ask what you put the thumb nick in with?
I struggle with those.

Thanks. I use a 7 inch abrasive cuttoff wheel in an arbor in the drill press.......holding the blade with a cross slide vice.
I plan to start pressing some of them in when I finally get a shop press. Then I can do long pulls and match strike nicks etc.

Darcy

[benny]

Nice looking folder.

[SKITCH]

Very nice. !!  Looks like it would just disappear in the pocket....until you need it.

[just_a_hunter]

I've been getting the bug bad to try a slip joint and studying as much as I can. I've also been trying to talk myself out of it because I'm super busy as is but in order to get better a fella has to be willing to grow.

These pocket knives are absolutely awesome examples Darcy.

Todd

[D.Ellis]

Thanks Todd. They are fun to make......but a bit time consuming. You could build several hunters in the same length of time for sure.

Darcy  

[FerretWYO]

What an awesome blade man. You have a real eye for everything you make.

Randy