Need advice on planning my first bow build

[LittleBen]

I've been reading over the forums here for what seems like an eternity, dreaming of the day when I can start my own bow build. I've been into traditional shooting for a few years and currently have a late 60's york thunderbolt which I greatly enjoy. I've been looking for another bow for some time, but keep returning to thoughts of building one myself.

I should state I have absolutely no experience in bow building, but have been designing and modeling sailplanes etc. since I was a kid so I'm familiar with working wood.
My main issue is that I have very limited if any access to power tools. With that said I am not shy of hand work at all.
I was hoping that some of you much wiser that I would have advice on what a reasonable project is given those limitations.
Really I have to assume all power tools are off the table ...

I don't know if this is important to the thoughts above but I draw roughly 25" and comfortable with about 40-45lbs

Hope to hear some thoughts from the veterans around these parts ...

[GREG IN MALAD]

I started with woodbows and would recommend the same. No power tools are needed and you dont need a bunch of room. Board bows are very inexpensive and shoot quite well. You will need a straight edge, draw knife, spokeshave, rasp, chainsaw file, and maybe a scraper.

[PEARL DRUMS]

Check out Poorfolkbows.com

[JD 9116]

I am NO expert by all means but I just started building as well. My first takedown recurve was built primarily with a skil saw, saw zaw (spelling?), sander drum on a drill, files and sandpaper. Not to say it is ideal but you would be amazed at what you can get done.

[John Scifres]

My first 10 bows were made with a hatchet, 4 way rasp and a butcher knife.  I made 20+ bows before I got a bandsaw.  So get a piece of wood, a hatchet or drawknife, a rasp, and a scraper of sorts and get to whittlin'.

[Stiks-n-Strings]

What John said.

 I have power tools but prefer the romance of hand tools when it comes to wood bows.

[perry f.]

Best advice I can give is just to jump in and get started. I put it off for a few years waiting until I could get the tools, but finally just jumped in. I've only made one self bow, about 4 board bows, and I just finished my first glass bow. Sure, you"ll make some mistakes, but that's cheap education. Just get started and if you run into questions along the way you can post your questions here, or search for the answer.. I'm sure most have already been asked. As for starters, I can second poorfolkbows.com

[LittleBen]

Thanks to everyone who's posted. I appreciate the push to just get started.

John and Kris, really like the idea of getting to it with basic tools ... sounds like I need to make my way to some hardwood boards and get to whittlin as you put it.

I'm sure I'll be posting shortly once I run into my first roadblock ...

[Dick in Seattle]

Ben... if you haven't, do check out Sam Harper's Poor Folk Bows web site:

 http://poorfolkbows.com/

Tons of good info on the minimal tool approach.

My own site has lots of info for beginning glass lam longbow builders, but I have to admit to being a very, very sick power tool junkie, so I don't think it would help you much