Oh yeah new toy

[kennym]

Let me see if I can tell which one its for, then whoever can tear theirs up first, I'll send it to em!

Check both ends of lumber, cause the back end may be thicker!! Don't ask how I know this!

LOL

Does the baby have an adjustable plate to keep too thick stuff from going in?

[Dmaxshawn]

Good deal rock on with it

[Roy from Pa]

I marter than the average bear.. I run the board through, taking a little off at a time on both side tills it even, then I do the tapers. Hain't no one ever learnt ya dat McKenzie?  

[cunruhshoot]

Always fun to get a new piece of equipment! Have fun...show us some finished veneers when you run them through.

[Roy from Pa]

[snapper1d]

Kenny I have got to be the first since mine in down right now!!!!

[Crooked Stic]

I just up graded my feed motor--Don't think they are nylon any more.

[Roy from Pa]

When I first got my sander, I wasn't too familiar with how things worked. So I cranked the handle up about 3 turns to take off more wood on the next test pass. It stalled the motor and the ckt breaker within the on/off switch tripped out at the same time. SO maybe they incorporated a safety feature into the newer models for dummies.

[bornofmud]

Yeah, I think Tenbrook said that they fixed the nylon gear issue when I brought it up somewhere else.  Should be good to go!  And Roy, that's a good sign haha, from early reviews of it, that definitely would have stripped your gear if it was the early nylon ones they were using.

[Roy from Pa]

It's McKenzies fault, he just told me to crank it up..