Limb broke, new one seem to hinge- opinions needed PLZ

[arachnid]

My guess is the the thinner spot is caused by over clamping that spot while gluing. It might have compressed the lam. Could be?

I very much doubt that...

[kennym]

Originally posted by arachnid:
 

     

The form is fine. I think I put too much clamping pressure on that spot. On the other hand, if I don`t clamp it tight it`ll give me a glue joint.
So, is it fixable?

Looking again, I think the form may have a very slight whoop in it there, and if you clamped with clamps, maybe the glue line is thinner there?  Bend a pc of glass around the curve in form (or limb) and check for any light shining thru.

[arachnid]

Well I checked again and there seems to be a bit of a flat spot on the form right about here:
   

Now, it`s hard to see and I had a hard time picking it up. Could this be the problem? And if so, is it fixable of do I neet to make a new form?

[kennym]

Yes, it could put a wiggle in the limb.

I'd still be interested in the limb thickness just off  wedge end and an inch and 2 inches out......

Originally posted by kennym:


I'd still be interested in the limb thickness just off  wedge end and an inch and 2 inches out......

Ditto....   Compare it to the other limb also...

Originally posted by Shredd:
 

Originally posted by kennym:


I'd still be interested in the limb thickness just off  wedge end and an inch and 2 inches out......

Ditto....  I would map it 5-6" out and also  compare it to the other limb... [/b]

[arachnid]

Ok, lots of pics but here goes. The right one it the lower limb, the left is the upper (newer) limb. I can see I was in a rush when making the new one, I got the thickness a bit off...
Pics go from end of the wedge (fade) to the end of the tip wedge. Mesurments are in milimeters.

         
     
 
               

[kennym]

That would make it hingey for sure. Mystery solved!

If you do an overlay on both limbs, just make sure they are the same thickness by leaving a bit more on the thin limb.

[arachnid]

Thanks Kenny.. I guess I should pay more attention to lam thickness  

I'll get that overlay done and keep you guys posted. And I think it's time for me to build another bow. A one piece this time.

Cool Beans...  Both limbs still look a little wonky at the fades...  Just could be the pics...  I would eyeball and check that form real good and correct it...  If it has a low spot fill it with some bondo...

[Crooked Stic]

The limb on the left appears to have a dip in it on the belly side. Could be a bad wedge grind or lam thickness that you calipers show. are you free handing your wedges? If so you need to compare thickness at different spots of the taper.