I,ve always glued mine with either hot melt, Tite Bond or epoxy. I "believe" Golt Tip says to use epoxy and not to use hot melt. They have a site that may tell you.
I cheat a little when I bareshaft tune and I'm cutting the shaft down after every few shots. I use scotch tape around the shaft and field point. It will hold for few shots.
If you do elect to use hot melt, be extra careful. Any heat applied directly to the shaft will destroy it. I ruined a shaft just touching it against the rim of a steel pot, while I was heating the field point with boiling water. Hot melt can lead to other problems too. On hard impacts the hot melt tends to break loose, resulting in a bulged or split tip.
I have used hot melt on carbon, but I think it and poor shaft preperation has resulted in many of the complaints on carbon shafts.