W2 & jigged micarta hunter

[bjansen]

Here is a little hunter I finished up in jigged Micarta.  61.5RC W2 Blade and stainless shield.  I wanted to make a fixed blade that looked like a little trapper slipjoint I was working on....so I simply traced out the open profile of the slipjoint - you can see the resemblance in the last pic. 

[KSCATTRAPR]

Oh my, thats awesome! Do you mind sharing your process of giving the micarta the jigged look? That really gives it an amazing look and I bet it feels good as well!

[luciusx5]

Very unique and well made. Awesome job!

[bjansen]

Thanks and yes, happy to share.  I will first pre-shape my handles (I did this prior to gluing them on as I wanted to install and pin the shield in place to the scale..and I could not do that once the scales were glued on). After my scales were shaped, I used round edge wheel burr in my foredom.  Just run it at slow speeds and just eat away chunks and it gives a nice look and feel to the knife.

I then glued in and pinned my shield and then glued the scales on the knife.  Following the glue set up, I ground the oversized scales edges flush with the tang and then installed and peened the pins.

I got the 5/8" round edge wheel burr from McMaster Carr. 

[KSCATTRAPR]

Thanks for the response. i'm definitely going to give this a try!