do over ???

[rockkiller]

Well its been awhile since I have built a bow , but it seems I have not forgot how to screw up ( one of my better god given abilities ). While routing out the top part of the form I had a opps and put a divot in it, It is almost a 1/16 deep.
Its a Kenny M fhlb design and has the bow back facing up , so I was wondering if I should redo template and form or since its the top half of form with airhose and galvanized strip if it would be ok??


Thanks for any help

[Mad Max]

Put some tape on the side and mix up some smooth on and fill in the valleys, and file it back to smooth.
I heard that somewhere 

[Tim Finley]

Use Bondo and sand it out with a thin flexible board about a foot long covered with sand paper.

[Forwardhandle]

I have used epoxy putty the kind you knead together ,pressed it in  & sanded and face the form with .040 glass before

[skeaterbait]

I have used bondo on all my forms. As Ritchie said, sand it smooth then glue on your laminate/glass or whatever bed you are going to use.

[rockkiller]

It being the top half of form, does it need something ( laminate) ?? I thought only the bottom needed a laminate on it and the top didnt because of the air hose. Or does the top need it because of my screw up?

Thanks again

[kennym]

It will work like it is but I'd bondo it just for peace of mind.  The air hose should take  care of that.

[Crooked Stic]

I think you be okay to. But the bondo wont hurt.

[monterey]

Use Bondo and sand it out with a thin flexible board about a foot long covered with sand paper.

That's what I do too.  Have also used plain wood filler if it's going to have a cover over it.

I divot every form every time!    If you are careful you won't have a flat spot. 

[rockkiller]

Thanks everyone for the help