I was worried about starving all the glue joints if I relaxed the clamps and let the lams relax and pull apart. The thought of applying more epoxy to all the lams that pulled apart was very intimidating. I considered it, but decided to let it be. I figured I would have to strip all the epoxy off and re-clean every lam to do it right. I'm sure it will be ok structurally, but I am worried about the cosmetic side of it. I had to make a quick decision, and didn't have time to ask questions before I took a course of action, or in-action as it were. I have found tons of different recommendations on curing smooth on, is why I asked about the cure time. They vary from 1.5 hours to 8 hours, and temps from 150-200 degrees! I was afraid of getting the saran in between the lams, besides I hate that stuff. I sprayed silicone spray on the form and blocks. Hopefully it wont be too bad.