Limbs for silvertip

[Bear Heart]

Are there bowyers out there that will build limbs to fit a silvertip?  My father wants so lighter limbs but the real deal cost around $750.  Who builds a suitable set of limbs for less.  Otherwise he just might as well buy a new bow.

[tradtusker]

have you tried a wanted post on the classifieds they come up every now and then, some one may have some to sell

i remember my buddy looking into getting a new set from Dave and it was $700 plus i thought that was ...well you can get a lot of bow for $700 bucks

[Benny Nganabbarru]

I can't help you there, but as an interesting side-note, Dave Windauer of Schafer Silvertip Bows does make limbs for Bear take-downs.

[md126]

bear heart,  i'd try the classifieds. you can also call dave and see if he can take some weight off the limbs you have now, depending on how much lower you want to go.

mike

[KentuckyTJ]

The classifieds here worked for me. Just two weeks ago I wanted another set of limbs for my Morrison and after a WTB thread it was about 4 days when a member in North Dakota pm'd me with the perfect set.  They are on their way to me as we speak.

Lots of Schafer limbs out there I'd say your chances are good.

[Bear Heart]

How does he know if the used silvertip limbs will fit.  His is about six years old.

[tradtusker]

they should fit mate but they may not match up exactly with the riser. Best to Phone Beth at silvertip and tell here what bow you have and what limbs to look out for

[Robhood23]

It really depends on how old his tip is? I would think the newer CNC riser would match up with the newer limbs. I have mixed and matched with older ones and they don't match up very well but did work!

[PBNJ]

I think your price is a bit off on a new set of limbs from Dave. I checked a few days ago and a basic set with no special veneeres was 485.00. Not cheap but not 700.00 bucks either.Good luck, they do come up now and then on the classifieds.

[cacciatore]

You can also try to trade them,post on classified

[Benny Nganabbarru]

G'day RobHood23!

Dave has a CNC machine now? Cool! When did that happen? If that's the case, it means I could get another set of perfectly-matching limbs (one day) without sending the riser back.

Cheers,

Ben

[mtnbike]

The CNC is news to me also. I'll ask Dave about it this weekend. Our local club is hosting the Mt. Bowhunters Assoc. annual convention.

[wollelybugger]

How light are you looking for, I have a set I am not using. I think they are 40 plus at 30 inches. I will look if you are interested.

[Bear Heart]

He's looking for something in the low 50's @ 29".  His current limbs are 61# @ 29".  The Michigan winters aren't getting any warmer and his body isn't getting any younger.  This grip was customized for him and checkered so he hates to give it up.

[Robhood23]

Just wondering what you found out from Dave about the CNC?

[tyee]

Andy Mccoy at bezaleel could do it in a snap if he had the riser it would be faster to I think he could go down 5 # or so and have the same ftps

[groyce]

I would check with Beth. She had a couple of used sets just a while back. Check under the sponsors classified. I think they were posted there.