Spine question?

[Chris Surtees]

Just want to know if anyone else has experienced the same shaft being able to be shot from a bow with 4 different lengths and 3 different point weights.

Basically I can group some CX 150's that are 28 1/2" to 27" in half inch increments. I have 8 shafts 2 at each length with a regular insert and a 100 gr. brass insert. I have only been using 125 gr field points but all these shafts group in a 2" by 2" black diamond at 10 yards.

I have only been shooting in the house so 10 yards is all I can get.

The bows I have be using are 40# and 45# @ 26". Both of these bows also shoot AD trad lites @ 27" with a 75 gr brass insert and 125 gr point really well. I was told more than once that these arrows would be too stiff but they are working for me.

Chris

[vermonster13]

How are they fletched?

[katman]

How do they group compared bareshaft to fletched shafts?  1 1/2" that is a lot of change in spine on a carbon.

[Chris Surtees]

They are all para 3 fletch. I am going to change them to naner 4 fletch. I just got these and decided to mess around with them a little tonight.

I do not bare shaft tune. Never have liked it.

Chris

[JEFF B]

hey chris what sort of bow you shoot recurve or long bow

[Chris Surtees]

Jeff,

I shoot both, but both of the bows that I have been shooting the CX's out of are recurves. I have not got around to trying them out of my longbow yet.

Chris

[Turpentine]

CLS It's most likely got to do with the amount of centershot for the two bows.  Once you get past ten yards however, those arrows most likely will show some variance in point of impact.
I'm with you on the bareshafting, I've never liked it.  I tune with fletched arrows and broadheads.  I also practice with broadheads and rarely ever shoot field points. All of my hunting arrows, especially woodies, have been individually shot and tuned to my bow.  My last batch of Sitka spruce varied in finished length up to 1.25 inches in order to get good flight and same point of impact with brand new Zwickey Eskimos.  There must have been alot of variance in the spine even though they were supposed to be 65-69# range.
I guess I would try bareshafting if I had to start from scratch with carbons.  I'm sure it works.  I'm just hard headed and prefer my own method.
Turpentine

[aromakr]

CLS:
I'm with Turpentine on this one. I would guess your bow is cut past center, one of the advantages of this type bow is it allows you to shoot a wide range of spines. Once you reach the minimum spine needed for that bow, you can usually go over spine by 50-60 pounds and not see a difference in fletched arrows. I have one client shooting shafts that are spined 120# from a 74# bow. Where guys will run into problems is using very small diameter shafts in this type of bow. What happens is the center of the shaft ends up being past center of the limb center line, in that case just place something behind the strike plate to move the shaft over to center or less than center.
Bob

[Chris Surtees]

Thanks for the info. I found another post were this exact same thing was said.

I did finally shoot the shafts off of my longbow, which is not cut to or past center, and the shafts were way over spined.

I am headed to the range right now with all the shafts to see what they are doing at longer ranges.

Thanks again.