Author Topic: VPA 3 blade suppose to be 1 1/8 ??? (Read 365 times)

Mint Hill Mule · « **on:** November 16, 2009, 10:29:00 PM »

Got my VPA Terminators in the mail today, 200gr screw-in. Love them but when I measured the width they were slightly under 1". Thought they were suppose to be 1 1/8". Anyone else found this to be the case?

pdk25 · « **Reply #1 on:** November 16, 2009, 10:30:00 PM »

How are you measuring them?

George D. Stout · « **Reply #2 on:** November 16, 2009, 11:25:00 PM »

It's about the cut, not the diameter.

Boomerang · « **Reply #3 on:** November 17, 2009, 10:51:00 AM »

These are made from 1-1/8" bar stock. The cutting diameter is 1-1/8". The reason you are getting a smaller measurement across two blades is because on a 3 blade broadhead, the blades are 120 degrees appart and not streight accross from each other like a 2 blade broadhead, but yes they are 1-1/8" diameter.

Mint Hill Mule · « **Reply #4 on:** November 17, 2009, 10:56:00 AM »

Thanks for the info. My question has been answered.

News:

Author Topic: VPA 3 blade suppose to be 1 1/8 ??? (Read 365 times)

Mint Hill Mule

VPA 3 blade suppose to be 1 1/8 ???

pdk25

Re: VPA 3 blade suppose to be 1 1/8 ???

George D. Stout

Re: VPA 3 blade suppose to be 1 1/8 ???

Boomerang

Re: VPA 3 blade suppose to be 1 1/8 ???

Mint Hill Mule

Re: VPA 3 blade suppose to be 1 1/8 ???

Users currently browsing this topic:


LEFT HAND BOWS CLASSIFIEDS	TRAD GANG CLASSIFIEDS ACCESS	RIGHT HAND BOWS CLASSIFIEDS