Adhesive for Inserts??

[drewsbow]

Big Jim's hot melt

[Rustic]

Originally posted by Takedown:
To all you carbon arrow crafters:
What adhesive do you recommend for installing brass weighted inserts into carbon shafts?

So what do you folks recommend?
Harry

Hi Harry,
I have been using Bohning Iron insert for a couple of years, it works very well but the tip clogs easily. Now, I'm using Goat Tuff and so far so good.

[LB_hntr]

I use gorilla glue "blue impact resistant".
 Works great, available everywhere and you can get them out with just heating the insert a bit.
 Never had an insert pull out yet.

[duffer1565]

Have been using crazy glue for a few years and works great. Pretty cheap to boot. Just rough up the inside of the shaft a little to get a good bond.

[threeunder]

Originally posted by Stone Knife:
 

Originally posted by Bisch:
Quick Stick hot melt from Big Jim's. You won't have to worry about losing inserts in targets and can easily get them out any time you want. This stuff is the best glue out there!

   http://www.shop.bigjimsbowcompany.com/Quick-Stick-Hot-Melt-Glue-AA102.htm?categoryId=-1  

Bisch

I have had great success with this also. [/b]

Another fan here!  Great stuff!

[Shooty1]

JB Weld or even Gorilla 5 min epoxy.