Any 3 blade 100 gr 3:1 heads out there?

[BRONZ]

The Woodsman Elites are close to 3:1, but i was curious if there are any other 3 blade heads out there? I'm not finding much.

[dhermon85]

If your not finding them at known 'trad' sites, probably not.
Seen lots of 125s. Is 25 grains gonna hurt?

[dhermon85]

Also, are you looking for screw in or glue on? Have seen some 100 grain glue on snuffers

[Biathlonman]

100 grain snuffers has to be close.

[SlowBowinMO]

Snuffers are nowhere near 3 to 1 but they are one of my favorites and they are available in 100.  The only thing i can think of, 3rivers used to sell a 125 screw in low profile Woodsman.  I wonder what tbose would weigh with the adapters removed?   Or did you want screw in?

[BRONZ]

Screw in is what I'm after. Thx fellas.

[BRONZ]

I have 100 grain inserts btw. Don't want anyone to think I'm shooting only 100 up front. ☺

[Friend]

There are very few 2 blade BH's that atually have a 3:1 ratio.

Doubt there would be an available 3 blade with a design even close to an actual 3:1 ratio.

[nineworlds9]

Visit your local machine shop and have some 2-blade 3:1's made, honestly wouldn't cost all that much to them them cut/stamp some out of good steel for you, then you or they could braze them onto some screw in ferrules, and put an edge on them.

[Whip]

The Grizzly Instinct is the closest to a true 3/1 ratio 3 blade that I know of. They can be had as 175 grains as a glue on head.

In order to get a ratio like that and end up with an effective and legal cutting diameter (1 inch in many states) takes a lot of metal. I suppose the blades could be made of extremely thin material,  but that isn't a good option for a durable head.  

Bronz, I would think an easy option would be to just use a regular aluminum insert with a Grizzly Instinct and a glue on adapter.  That should put you a little over 200 total grains up front.

[zipper bowss]

The Instincts are 2 7/8" long and as far as I know are the longest 3 blade available today.It takes a lot of steel to get a head that long.
I do have some Instincts that got over ground. Since they were already less than the 1 1/8" we wanted. I took them on down to 1" cutting diameter. If I remember correctly they are still around 180 grains.They were originally meant to be 200's.
Bill

[karrow]

might have some more options in a 175 or 200 grain head and a stock insert. lots of combos to get the weight you want with all the inserts and adpts on the market.

[Adirondack Bowman]

The Instincts are a  great head. C

[Friend]

Would venture to estimate that there are no 3 blades readily available with actual MA's of 3:1.

Note: the 2 blade Tuff Head has a 2.88 MA.

A 3 blade would take a 4.5" Blade cut length, as measured horizonatally, with a 1" diameter to establish a 3:1 MA.